354

Help with decoding your Hemi engine.

Moderators: scottm, TrWaters, 392heminut

badcat69
Posts: 2
Joined: Sat Mar 01, 2008 7:43 pm
Location: Helena Montana

354

Postby badcat69 » Sat Mar 01, 2008 10:10 pm

I am trying to find out what and value of a Hemi engine I have.
It is a354 as far as I know. It has a VT575 on the left front of the engine block. I believe it is a truck block and it has a dual two(or single) carb intake.
The head code is 1733463 which does show a 354. Any help would be greatly appreciated.
Thanks

George
Posts: 636
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Postby George » Mon Mar 03, 2008 10:11 am

You sure it's 575?

badcat69
Posts: 2
Joined: Sat Mar 01, 2008 7:43 pm
Location: Helena Montana

hemi

Postby badcat69 » Mon Mar 03, 2008 12:57 pm

yes on the front of the block it says VT 575 and right under it is and I

George
Posts: 636
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Postby George » Mon Mar 03, 2008 5:57 pm

Not in the list of codes in Leo's book. There is a casting # between the head & valley cover, driver's side rear. Hard to see with intake on. There have been reports of a few with 354 casting numbers, bot bored to 331, guess you'll have to measure stroke & bore to be sure.

Powerflite
Posts: 26
Joined: Wed Oct 05, 2005 8:22 pm
Location: Los Angeles, CA

Re: 354

Postby Powerflite » Mon Apr 14, 2008 4:30 pm

Can you tell me if those heads have water outlets on the ends or in the center of the intake mount? I have heard of truck motors with dry intakes and am trying to figure out which ones (if any) they are. Thanks.


Return to “Decode My Hemi”

Who is online

Users browsing this forum: No registered users and 2 guests