I need to change the reareand fluid. I have the limited slip 9" rear end.
How much fluid do I need buy?
How much friction modifier do I need?
Where is the fill hole????
Thanks
Changing rearend fluid?
Moderator: scottm
Changing rearend fluid?
2003 Ram QC 1500 4X2 - K&N air filter, spray in bedliner, nerf bars, Trans temp gauge
Axel oil change
Summit, PAW & others have oil for posi units. I filled a dry 9" a few yrs ago, seems that it was 4 qts. Fill hole can be on the front or rear of dif. depending on yr. If someone did a mismatch it"s possible to not have one!
That big circle thing is the fill plug? How does it come off?SoCalHemi04 wrote:The 9.25 rear end holds 2.5 Qts... the full plug is 1/3 up on the cover. Add 4 oz of limited-slip additive, and use 75w-140 syn lube. i will cost you over $50 to di it yourself.
Thanks
2003 Ram QC 1500 4X2 - K&N air filter, spray in bedliner, nerf bars, Trans temp gauge
Remember this when refilling the axle fluids....dont fill till it comes out of the fill hole! 9 of 30: POWER TRAIN:AXLE ASSEMBLY
Bulletin Number: 0300104A
Bulletin Date: MAY 2004
THE AXLES ARE LOCATED CONSIDERABLY HIGHER THAT THE ACTUAL FLUID LEVEL. FILLING THE AXLE UNTIL THE FLUID COMES OUT OF THE FILL HOLE WILL OVER FILL THE AXLE, WHICH COULD CAUSE FLUID FOAMING. *MN *TT
Bulletin Number: 0300104A
Bulletin Date: MAY 2004
THE AXLES ARE LOCATED CONSIDERABLY HIGHER THAT THE ACTUAL FLUID LEVEL. FILLING THE AXLE UNTIL THE FLUID COMES OUT OF THE FILL HOLE WILL OVER FILL THE AXLE, WHICH COULD CAUSE FLUID FOAMING. *MN *TT