hi there!
I am swapping a crate 5.7 hemi in my 68 super wagoneer. I would like to use the 45RFE behind it, but don't know what to use for a controller. is there a stand alone TCM for this transmission. I don't realy want to use the 727. is anyone running this combo? thanks!
crate hemi transmission questions
Moderator: scottm
-
- Posts: 1
- Joined: Thu Sep 14, 2006 7:50 pm
- Location: portland
-
- Posts: 37
- Joined: Sat Dec 31, 2005 7:54 am
- Location: MARYLAND
- Contact:
I know the crate engine electronics won't run that trans.The only way I can see is to run factory Chrysler electronics.The 2003 Rams used seperate engine and trans computers,2004 and up, it was all in one computer.You could go either way,but I would buy a junk yard low milage engine,rather then a crate engine.Its cheaper and you would get the computer and accesories
-
- Posts: 143
- Joined: Thu May 18, 2006 11:31 am
- Location: UK
Hi,
Have you tried a search on Street & Performances website ? They have plenty of stuff on engines. Not sure what stuff they have on transmissions though. They may be able to give you some guidance on this.
Try: sales@hotrodlane.cc as a contact address.
Good luck !
Mike
Have you tried a search on Street & Performances website ? They have plenty of stuff on engines. Not sure what stuff they have on transmissions though. They may be able to give you some guidance on this.
Try: sales@hotrodlane.cc as a contact address.
Good luck !
Mike
Beep ! Beep !
Try the link below as they have a controller that works with the 5-45RFE. I am assuming of course that you will be using a stand alone engine computer also. A buddy has one on his 5.7 Hemi truck.
http://www.powertraincontrolsolutions.c ... ent-4.html
http://www.powertraincontrolsolutions.c ... ent-4.html
2005 Dodge Ram 2500 RCSB ThunderRoad Hemi Sport w/STS turbo