528 performance

Discussion of Hemi crate engines.

Moderator: scottm

Post Reply
ply426
Posts: 1
Joined: Wed Jul 24, 2002 1:06 pm

528 performance

Post by ply426 »

Anyone know of any "street trim" 528s out there? If so, how do they run? I'm nearly ready to install mine and I'm wondering what to expect.
MG42pillbox
Posts: 194
Joined: Mon Jul 14, 2003 7:29 pm
Location: Phoenix AZ

Post by MG42pillbox »

I have heard #s from High 11s and as good as low 10s. The thing RUNS. 8)
One whose life is Infecting others with Falsehood, shall fall greater than any of their Victims.
Hemidakota
Posts: 149
Joined: Thu Jul 17, 2003 9:31 am
Location: Oceanside

Re: 528 performance

Post by Hemidakota »

ply426 wrote:Anyone know of any "street trim" 528s out there? If so, how do they run? I'm nearly ready to install mine and I'm wondering what to expect.
ON which vehicle?

The truck below has a crate 528 with 710HP (TB unit not carb).
Steve
Future Purchase: 2006 Charger SRT-8/2006 MegaCab 6.1 Hemi
Image
"Coming soon 600HP SRT-10 to pull the SRT-4 & SRT-8 Charger to the track!"
MG42pillbox
Posts: 194
Joined: Mon Jul 14, 2003 7:29 pm
Location: Phoenix AZ

Post by MG42pillbox »

People with B bodies.
One whose life is Infecting others with Falsehood, shall fall greater than any of their Victims.
silverstiman
Posts: 2
Joined: Wed Jul 14, 2004 1:33 am
Location: One rock in the pacific called Oahu, HI
Contact:

need hemi trans for 4x4 jeep

Post by silverstiman »

I have been tryin to find a trans for my 81 jeep wagoner and i am not havin any luck... The engine is going to be a 528 crate hemi but theres no transmission and transfer case to back it up :cry: :( ... I need some help.. :(
LaddieHanus

Post by LaddieHanus »

Get a bigblock 727 and a 727 out of a wagoneer I'm not sure when Wagoneers started useing them but I think it was 80. Take the jeep trans tailhousing and output shaft and rebuild the bigblock 727 with those parts. For the Tcase if you have the diff on the drivers side (which I think 81;s had) use a tcase out of a 94+ V8 truck (diesel and V10 has wrong spline count) or an Atlas II from advance adapters ($2k). Parts Milke (www.partsmike.com) is a good source. With your engine the Atlas would make more sense.

Laddie Hanus
silverstiman
Posts: 2
Joined: Wed Jul 14, 2004 1:33 am
Location: One rock in the pacific called Oahu, HI
Contact:

cant use 727 engine

Post by silverstiman »

The only engine i can use is a hemi only and has to be a 528... I cant find any information to see if the 727 transmission will bolt up to the big hemi... any other info would be helpful..
MG42pillbox
Posts: 194
Joined: Mon Jul 14, 2003 7:29 pm
Location: Phoenix AZ

Post by MG42pillbox »

it does
One whose life is Infecting others with Falsehood, shall fall greater than any of their Victims.
Post Reply