Hemi piston compression height question

Discussion about the Hemi in general.

Moderator: scottm

Post Reply
darrenb811
Posts: 3
Joined: Fri Mar 06, 2009 5:28 pm

Hemi piston compression height question

Post by darrenb811 »

I am building a world products block and will use a 4.500 stroke crank with 7.100 rods, w/4.25 finished bore.. standard deck height 10.725.
I need to get custom pistons made (J/E). Does anyone know if the Piston compression height (calculated to be 1.375" puts the pin into the oil ring land ..?.. probems with this scenario...? ... balancing ..?
Any help, suggestions or comments appreciated! :roll:
Post Reply