dumb dodge question

Discussion about the Hemi in general.

Moderator: scottm

timshemi
Posts: 16
Joined: Sat Dec 12, 2009 10:58 am

dumb dodge question

Postby timshemi » Fri Feb 10, 2012 8:19 pm

i have a junk 241 with usable heads and a good 325 with no heads, will the 241 heads work on the 325? i know the heads will physically fit and i know about the tall deck low deck stuff, but what i am asking is if the 241 heads will flow enough to feed the 325? is this a real concern, or am i just over thinking? not looking to make some wicked race engine, just a healthy street engine. thanks

George
Posts: 623
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Re: dumb dodge question

Postby George » Sun Feb 12, 2012 9:59 am

timshemi wrote:i have a junk 241 with usable heads and a good 325 with no heads, will the 241 heads work on the 325? i know the heads will physically fit and i know about the tall deck low deck stuff, but what i am asking is if the 241 heads will flow enough to feed the 325? is this a real concern, or am i just over thinking? not looking to make some wicked race engine, just a healthy street engine. thanks

Check out Doc Fromader's 315 build @ www.webrodder.com He used 241 heads & offers commentary on them.


Return to “General Hemi Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests