low deck stroker info

Discussion of the 331-354-392 HEMIs.

Moderators: scottm, TrWaters, 392heminut

Post Reply
johnny5
Posts: 128
Joined: Mon Dec 05, 2005 3:52 pm
Location: St Charles, MO

low deck stroker info

Post by johnny5 »

Peter, how much clearancing did you have to do with your 4.25" stroke/6.625" stock rod 354 stroker motor? Were the pins still below the oil ring land or did you have to use buttons to hold them in?
Bailiesdad
Posts: 433
Joined: Sat Dec 01, 2001 6:00 pm
Location: Maryland

Post by Bailiesdad »

Very little cutting using aftermarket steel rod bolts with reduced head size 12 point nuts, the piston rings did not go into the pin area.

I even looked at cat style cap rods that would require no cutting at all. I did not want to wait 6 months to get them made.
Post Reply