K1 Rods?

Discussion of the 331-354-392 HEMIs.

Moderators: scottm, TrWaters, 392heminut

Post Reply
NE57
Posts: 192
Joined: Fri Mar 27, 2009 12:54 pm

K1 Rods?

Post by NE57 »

I see that K1 rods designed for the 392 actually use big block mopar bearings. Is this a simple matter of snapping in the bearing or are there some mods needed that I haven't read about? Like narrowing the bearing?
DblAdigger
Posts: 86
Joined: Mon Feb 02, 2004 1:40 pm
Location: SoCal

Re: K1 Rods?

Post by DblAdigger »

What is the width of the big end of the K-1 rod?
Chuck Stevens
Some people can break a cannon ball, in a sand box, with their bare hands.
NE57
Posts: 192
Joined: Fri Mar 27, 2009 12:54 pm

Re: K1 Rods?

Post by NE57 »

NE57
Posts: 192
Joined: Fri Mar 27, 2009 12:54 pm

Re: K1 Rods?

Post by NE57 »

Campbell Enterprises tells me no mods, 'just bolt em together'


that makes the decision easier, I think


but then I think too much
budmspeeco
Posts: 133
Joined: Tue Dec 21, 2004 5:35 pm
Location: South Houston, Texas

Re: K1 Rods?

Post by budmspeeco »

I agree. Y T 2 M !!! Buddy
'48 anglia
Post Reply