Measurements Needed

[NE57]

My block is still at the machinist but I'd like to start planning my home fab intake manifold.

On a 392 I'm looking for the following measurements...

1) distributor offset from engine centerline

2) Distributor center to the last intake manifold bolt hole(drivers side), or dist to engine centerline(front to back), what ever is convenient

I need to make sure I leave enough room for the distributor. Its going to be a long plenum. I've got the heads here and a ratty stock manifold to mock up from.

If someone has a motor they can measure for me I'd sure appreciate it.

thanks