A body Hemi headers ?
Moderators: scottm, TrWaters, 392heminut
A body Hemi headers ?
Does anyone mame a set of headers for A bodys ? Hooker doesnt list any on their site.
-
- Posts: 433
- Joined: Sat Dec 01, 2001 6:00 pm
- Location: Maryland
My TTI's don't have a bead of weld to seal the gasket. The Hookers that I replaced did though and always had a hard time getting them to seal. In addition to flattening tubes to get them to fit. The TTI's fit with no modifications and increased my performance by 3 tenths in the quarter mile. Just my opinion.
Yes they are 2 1/8" with a 3 1/2" collector for an e-body. Check out their website at www.ttiexhaust.com
In the latest issue of National Dragster there is a Hooker ad that lists Super Competition adjustable race headers for A bodies with a 426 Hemi. Part number is 5481HKR. Fits 68-75 A-bodies, 2 1/4" x 24-30" tube diameter and length and a 4" collector. The website is www.ilovemyhookerheaders.com They are listed in the adjustable race header section.
-
- Posts: 9
- Joined: Fri May 19, 2006 4:45 pm
I made my own......the torsion bars slide right through them and nothing touches. 1 7/8 x 30" equal length tubes (street). The car I'm building now has a custom built (my own) front subframe with coil-overs......B-E body TTi's fit up nicely. In the past I have used Hooker Super-Comps (they make them - think SS/AA Dart) but they hang extremely low.......too low for the street.