Newbie

1st Gen HEMI projects and products.

Moderator: scottm

Post Reply
zigs
Posts: 5
Joined: Tue Feb 08, 2011 3:27 pm

Newbie

Post by zigs »

I'm new to this site . I have a little old with the and a little older. I'm building a 68 Dart with a 354 Hemi. I was reading a thread a couple days ago about a 392 swap so I thought i would share. is it practical...... no strictly show and go.
Dart001.jpg
You do not have the required permissions to view the files attached to this post.
mart
Posts: 536
Joined: Tue Mar 22, 2005 2:06 pm

Re: Newbie

Post by mart »

The 354 will be *marginally* easier to do
and a better fit in an A-body than the 392.
The 331-354's have a lower deck height
and thus are just a bit narrower and about
40 to 50 lbs. lighter. It's definitely not a
"bolt in" deal and will take some serious
work, and fabrication skills - but it's
do-able. Good luck and have fun! :)

mart
================================
zigs
Posts: 5
Joined: Tue Feb 08, 2011 3:27 pm

Re: Newbie

Post by zigs »

mart wrote:The 354 will be *marginally* easier to do
and a better fit in an A-body than the 392.
The 331-354's have a lower deck height
and thus are just a bit narrower and about
40 to 50 lbs. lighter. It's definitely not a
"bolt in" deal and will take some serious
work, and fabrication skills - but it's
do-able. Good luck and have fun! :)

mart
================================
Thanks .I've had the engine in for a year.
Post Reply