will it fit?-also need heads
Moderators: scottm, TrWaters, 392heminut
-
- Posts: 3
- Joined: Fri Feb 10, 2006 6:32 pm
- Location: n.e.arkansas
will it fit?-also need heads
I have come across a 4-barrel intake for a hemi, casting #B1634262-2 will this fit my 241, also looking for better flowing heads for this engine is anything interchangable with it
Re: will it fit?-also need heads
The 270, 315, & 325 heads fit. 315 & 325 heads are best. The intake is for a Dodge D-500 315 Hemi, it is a raised block engine & won't fit the 241.hoxiehippy wrote:I have come across a 4-barrel intake for a hemi, casting #B1634262-2 will this fit my 241, also looking for better flowing heads for this engine is anything interchangable with it
-
- Posts: 3
- Joined: Fri Feb 10, 2006 6:32 pm
- Location: n.e.arkansas
will it fit
Thank you for the reply to my inquire -this is my first hemi project and am still learning. One last question if the 315 or 325 heads are best for this 241 (if i can find a set of either ones) since these are off a raised block engine what intake would i have to use, one off a 241 or a raised block engine? Thanks for all the advise.
-
- Posts: 23
- Joined: Thu Nov 24, 2005 7:28 pm
- Location: Barrie Ontario, Canada
315 heads on low deck engine.
I run 315 heads on my 270 with no problems. I even run Isky adjustable pushrods which are a little larger in diameter than stock ones , and I have no clearance issues.
Peter
Peter
Hemi T