Dodge 241

Discussion of the Early Dodge / DeSoto HEMIs.

Moderators: TrWaters, 392heminut, scottm

Post Reply
Red Ram 241
Posts: 1
Joined: Tue Feb 19, 2008 6:59 pm

Dodge 241

Post by Red Ram 241 » Tue Feb 19, 2008 9:37 pm

Have a chance to get Dodge 241, know nothing about Hemi's. Is there after market speed equipment readily avaiable ( 4 barrel intakes, cams, headers, etc.?) How about assemble manuals, suppliers? Is there an oil pan for it with sump to the rear? I would appreciate any help or suggestions.
Bob

George
Posts: 643
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Post by George » Wed Feb 20, 2008 8:43 am

Check out www.hothemiheads.com Also get Tex Smith's hemi Book. It's Chrysler oriented more than Dodge & DeSoto, but it helps. While I wouldn't do some of the exotic things Doc did....check out Doc Fromader's 315 build on webrodder. Some 4 bl intakes were made for the 270 & will fit. Cams used to be regring only, if new arn't at hotHeads, they still are.

392heminut
Posts: 488
Joined: Sat Nov 30, 2002 2:16 pm

Post by 392heminut » Wed Feb 20, 2008 8:46 am

Check out Hot Heads Research at the link below. It's run by a great guy by the name of Bob Walker. Pretty much anything that's available will be there. I'll say ahead of time though, there's not a lot of stuff out there for the 241.

www.hothemiheads.com
Owner of the Poor Man's Hemi Cuda

Hannah1935
Posts: 45
Joined: Sun May 21, 2006 12:27 pm
Location: California

241 Dodge Red Ram Hemi

Post by Hannah1935 » Sat Mar 01, 2008 8:34 pm

Hello..I just recently finished building a 241 and if you need help let me know..
Duane..
Hello..I have a 1935 Tudor Ford Slant back Sedan...My hobbies are Stromberg 97s and intakes manifolds..

Badhemi
Posts: 1
Joined: Tue Nov 27, 2007 5:02 pm
Location: Barossa Valley South Australia

Post by Badhemi » Thu Mar 06, 2008 3:31 am

Can help with all new custom made oil pans either full length or rear sump.
Cheers,
Badhemi

Post Reply