interesting 331 truck motor

Discussion of the Marine / Industrial Hemis.

Moderators: scottm, TrWaters, 392heminut

johnny5
Posts: 128
Joined: Mon Dec 05, 2005 3:52 pm
Location: St Charles, MO

interesting 331 truck motor

Postby johnny5 » Thu Mar 02, 2006 6:12 pm

I tore down the 331 truck motor I recently acquired. It's stock and otherwise un-touched:

VT 348 (yes, the number is correct, and yes, it's a 331 Chrysler)
Block# 1330129-2 (non-extended bellhousing)
Head# 1536367-1 (large ports, tall skinny water heat x-over)
Plain no-name valve covers
4-bolt exhaust manifolds (no casting# yet)
Single 1bbl intake manifold# 1536375-1
Full length sump oil pan

The interesting part about this motor is the number stamped on the valley cover. It follows the Dodge numbering convention for some reason. The heads seem to be an un-documented casting#.
Last edited by johnny5 on Thu Mar 02, 2006 9:08 pm, edited 1 time in total.

George
Posts: 626
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Postby George » Thu Mar 02, 2006 7:27 pm

Single 1 bl???

johnny5
Posts: 128
Joined: Mon Dec 05, 2005 3:52 pm
Location: St Charles, MO

a BIG 1bbl carb

Postby johnny5 » Thu Mar 02, 2006 9:09 pm

Strange but true. I updated the original post with the casting#.

Bailiesdad
Posts: 438
Joined: Sat Dec 01, 2001 6:00 pm
Location: Maryland

Postby Bailiesdad » Fri Mar 03, 2006 7:04 am

That was a 1954 Dodge truck 331 cu in motor with a set of 331 truck heads, Leos' book documents them.


Return to “Marine / Industrial Hemis”

Who is online

Users browsing this forum: No registered users and 1 guest