MARINE HEMI INTO CAR HELP

Discussion of the Marine / Industrial Hemis.

Moderators: scottm, TrWaters, 392heminut

johhno
Posts: 1
Joined: Thu May 11, 2006 3:26 am
Location: australia

MARINE HEMI INTO CAR HELP

Postby johhno » Thu May 11, 2006 4:39 am

Hi
What problems are there associated with putting a marine Hemi 354 into a hotrod. I have heard that there are extra holes in the water jacket. Would these create a problem. Any idea what gearboxes would mate up to this engine? Any help at all would be much appreciated including solutions.
John

George
Posts: 627
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Postby George » Fri May 12, 2006 12:23 pm

51-54 car front covers cover the extra holes. If you don't mind running an electric fuel pump you can use the Hot Heads aftermarket cover. There are a lot of tranny adaptors for GM & Mopar trannys.

George
Posts: 627
Joined: Wed Aug 25, 2004 4:12 pm
Location: Fl

Postby George » Fri May 19, 2006 3:45 pm

It should be noted some marine hemi turn the right way & some the wrong way! If you put one in that turns the wrong way, strange things will happen when you put it in gear! I've hear that each has its own firing order & that both are different than the car.

Bailiesdad
Posts: 438
Joined: Sat Dec 01, 2001 6:00 pm
Location: Maryland

Postby Bailiesdad » Fri May 19, 2006 6:53 pm

The crankshaft will be drilled from the snout to the front main bearing journal oiling system, You gotta plug that, the front of the crank will not have the step for a timing gear, you gotta weld that, the & right left hand rotation engines will need new cam, inetemediate shaft, and distibutor.

Good Luck getting the gear case gear off the front of the crankshaft, it is .005 press fit solid steel on solid steel. You have to heat the gear and chill the crank to get them off. Never seen a home shop guy accomplish the task. Thise bearing on the gear are zero tollerance bearings that are very very expensive, also.

Other than the above and the heads having a different heat riser opening, everything internally is useable.

George ever get the Hemi n the stang?


Return to “Marine / Industrial Hemis”

Who is online

Users browsing this forum: No registered users and 1 guest